Close button: press this button to close card management dialog box and go back
to the main window.
Basic Steps for Setting up Cardholder Database
When setting up a cardholder database in a new system, users should follow the steps
below:
1.
Determine which cards should be registered in which controllers (applicable
only when the system has multiple controllers).
2.
Register cards (manually or automatically).
3.
Edit cardholder profiles.
4.
Edit card(s)’ access attributes.
The details of each step will be addressed in the following sections.
Register Cards
Each cardholder must posses a valid, registered card. It is important to register each
card in the database correctly, to ensure proper operation. There are three ways to
register a card into the system, each method is explained below.
Note: before registering cards, determine to which controller each card will be assigned.
Register Cards Manually
Figure 8.4 Card manual register dialog
The steps to register cards manually are described as below:
1.
As shown in Figure 8.4, press
2.
Type in the card number to be registered. This is the 8 digit number printed on
the card. Press
to confirm. This card number will be added in the
Cardholder’s personal profile database.
60
Summary of Contents for Flex1.0
