3.
Press the
button on card attribute toolbar to register the card on the
selected controllers 0001 and 0002 by default mode (For default mode, refer to
section of card access attributes setting). Controllers that have already registered
the selected card will no longer appear in the controller list as in Figure 8.10.
Figure 8.9: Check controllers to apply the cards to
Figure 8.10: Card applied to selected controllers
4.
Or press
to apply the selected card to all controllers instead of selecting
desired controllers in the controller list. The result of pressing “All” is shown in
Fig. 8.7.
Remove Cards from Controllers
To remove a card from controllers, follow the steps described below:
1.
Select the cardholder in the cardholder list whose card’s attributes are going to
be set.
2.
Select a controller in the card access attribute list by clicking the table.
3.
Press the
button to delete the card from the selected controller. A
confirmation dialog box will pop up as in Figure 8.11. Press “Yes” to perform
the deletion. The removed controller will appear in the controller list. Press
“No” to cancel the operation.
64
Summary of Contents for Flex1.0
