M 11 6 - E Z 7 0 0 - 0 0 1
HIGH PERFORMANCE
BULLET CAMERA
O P E R AT I O N M A N U A L
Th a n k yo u fo r c h o o s i n g o u r h i g h q u a l i t y c a m e r a .
B e f o r e a t t e m p t i n g t o c o n n e c t o r o p e r a t e , p l e a s e r e a d a n d
fo l l ow t h e s e i n s t r u c t i o n s.
FEATURES
• 1/3¨ 960H SONY EXview HAD CCD II
• High Resolution of 720TV Lines
• OSD (Joystick)
• Multi Language
(ENGLISH / JAPANESE / GERMAN / FRENCH /
RUSSIAN / PORTUGUESE / SPANISH / CHINESE)
• 2DNR
• Privacy Zone 4Zones
• Motion Detection 4Zones
• DC12V/AC24V Dual Voltage
• ATR (Adaptive Tone-Curve Reproduction)
• Outstanding Durability with IP67
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Any changes or modifi cations in construction of this devies which are not
expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Caution -
CAUTION
1. A regulated DC12V 300mA power supply is recommended for use with
this camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be
out of subject.
2. It is recommended that the camera is used with a monitor that has a
CCTV quality 75 video impedance level. If your monitor is switched to
high impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the
internal componets. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or refl ective light,
which may cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.”
Note -
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
WARNING -
Bullet
Camera
Mounting
Bracket
Screw 3ea
Operation
Manual
97
Ф
60
Mounting Hole
(1/4"-20UNC)
41.5
36
3-Ф
4.5
When you install the camera, please glue up the end of
cable to keep it stable in order to protect the camera from
the humidity problems.
Focus Ring
(NEAR
׳
FAR)
Zoom Ring
(Wide
׳
Tele)
CAUTIONS
CAUTIONS
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European
countries with separate collection systems)
This marking shown on the product or its literature, indicate that
it should not be disposed with other household wastes at the end
of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate
this from other types of wastes and recycle it responsibly to
promote the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes
purchased this product, or their local government offi
ce, for details
of where and how they can take item for environmentally safe
recycling.
Business users should contact their supplier and check the terms
and conditions of the purchase contract.
Household users should contact either the retailer where they for
disposal.
C AU T I O N
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER(OR BACK). NO USER. SERVICING TO
QUALIFED SERVICE PERSONNEL.
This symbol is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's
enclosure that may be of suffi
cient mangnitude to constitute
a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance(servicing) instruction in
the literature accompanying the appliance.
COMPONENTS
MOUNTING POSITION
CONNECTION
DIMENSIONS
Unit(mm)
DC12V/AC24V
BNC FEMALE
VIDEO IN
TV MONITOR
1/4"-20UNC DP4.5
Joystick OSD Control
128.5
Ф
36
118.5
51.2
Ф
29
33.5
124
