EHN7221/7260/7360
66
【
Alarm I/O Settings
】
Input 1 Trigger Type:
Select
Normal Open
or
Normal Close
from the drop-down list.
Output 1 Contact Type:
Select
Normal Open
or
Normal Close
from the drop-down list.
【
Tamper Detection Settings
】
Tamper Duration Time:
Enter a duration time between 10 and 120 seconds.
【
Trigger Options Settings
】
Pre-trigger Buffer
second:
Enter the duration (between 10 and 120 seconds) for the
buffer. This will determine the amount of footage (length of time) before the event trigger
moment that will be included in an event-triggered video recording, if that buffer and video
recording has been enabled in the Event Management field.
Post-trigger Buffer
second:
Enter the duration (between 10 and 120 seconds) for the
buffer. This will determine the amount of footage (length of time) after the event trigger
moment that will be included in an event-triggered video recording, if that buffer and video
recording has been enabled in the Event Management field.
Click
Apply
to apply the changes or
Cancel
to cancel the changes and return to the previous settings.
【
Schedule Settings
】
Users can configure the recording schedule here. Select the desired recording
types among the options below. Click and drag the cursor on the time block, which will be applied
with the selected recording type.
Event (Red):
Select for the camera to activate all the Event Recording (Alarm Input, Manual
Trigger, Motion Detection, Tampering Detection).
Schedule (Green):
Select for the camera to activate normal recording. The events will not be
marked in the recording file.
Event + Schedule (Yellow):
Select for the camera to active both of the configured Event and
normal recordings. The events will be marked in the recording file.
Deselect (Grey):
Select for the camera to stop recording.
Click
Apply
to apply the changes or
Cancel
to cancel the changes and return to the previous settings.
【
Motion Settings
】
Use this page to configure up to four areas in which motion will be detected.
When a motion is detected by the camera, the motion detection icon
will appear at
the top right corner on the Live View Window to alert the user. This function can also be linked
with correctly configured Events to trigger Event reactions like the activation of video recording
periods, snapshots, etc.
To set up the Motion area:
1.
Check the
Enable
box to enable the selected area.
2.
Select a sensitivity value of the motion detection sensor function.
