Troubleshooting
If you experience a problem with your appliance or are concerned that the appliance is not
functioning correctly, you can carry out some easy checks before calling for service, please
see below.
Warning!
Don't try to repair the appliance yourself. If the problem persists after you have
made the checks mentioned below, contact a qualified electrician, authorized service
engineer or the shop where you purchased the product.
Problem
Check whether the power cord is plugged into the power
.
outlet properly
Check the fuse or circuit of your power supply
replace
,
if necessary
.
The ambient temperature is too low
Try setting the chamber
.
temperature to a colder level to solve this problem
.
The interior may need to be cleaned
Some food
containers or wrapping cause odours
,
.
Possible cause
Solution
&
Appliance is not
working correctly
Odours from the
compartments
The sounds below are quite normal
:
Compressor running noises
.
Clicking noise before the compressor starts
.
Noise from the
appliance
Other unusual noises are due to the reasons below and
:
may need you to check and take action
The cabinet is not level
.
The back of appliance touches the wall
.
Bottles or containers fallen or rolling
.
The motor runs
continuously
It is normal to frequently hear the sound of the motor
,
:
it wil need to run more when in following circumstances
Temperature setting is colder than necessary
Large quantity of warm food has recently been stored
.
within the appliance
The temperature outside the appliance is too high
.
Doors are kept open too long or too often
.
After your installing the appliance or it has been
.
switched off for a long time
A layer of frost occurs
in the compartment
Ensure food is placed within the appliance to allow sufficient
ventilation
Ensure that door is fully closed To remove the
.
.
frost
please refer to cleaning and care chapter
,
.
●
●
●
●
●
●
●
Temperature inside is
too warm
You may have left the doors open too long or too frequently or
;
the doors are kept open by some obstacle
or the appliance is
;
located with insufficient clearance at the sides
back and top.
,
Temperature inside is
too cold
Increase the temperature by following the
Controller part.
”
"
chapter
.
Doors cant be closed
easily
Check whether the top of the refrigerator is tilted back by
mm to allow the doors to self close
or if something
1 0 - 1 5
,
.
inside is preventing the doors from closing
●
16
Summary of Contents for EVUD4020
