Evergreen ZA720, Assembly Instructions Manual

Maintenance:

In a timely manner the centralizer skeleton.

 1.If the ground not level off, loose soil layer thickness is differ, wall shed may tilt to one end, once found, should be timely the centralizer, in case of deformation.
   The shed may be slant when facing the un-level ground or loose soil layer, please righting the shed urgently to avoid deformation
 2.Prevent increased loading-weight artificially.
    Don't let any lentils, towel gourd, pumpkin and climbing fruits and vegetables to grow up on the canopy, otherwise if it is windy and rainy, skeleton is
    unbearable, and easy to cause skeleton crack, broken, collapse Avoid kinds of  vine plant climbing on the canopy, or it can not bearing for the wind and heavy
    rain, broken,collapse may accured.

The sunshine board maintenance:

  1.IIn the using canopy, note do not use sharp objects collision films, avoid to cut films. Be careful not collide with a sharp object films,in order to avoid scratched
     films when using.
  2.If films appear rupture, can use glue to repair or repair with transparent tape. Available polyurethane adhesive for repairing. Often keep the films clean, generally
     the PC sheet replacement using 6 ~ 10 years later, so as not to affect the light transmittance.  Using transparent tape adhesive to patch cracks of film when any
     broken in case .Keep clean films,it will better replaced by new panels after 6-10years to avoid affect the Light transmittance
  3.The flame retardant in polycarbonate material, but still need to stay away from fire, avoid softening deformation.
      As Polycarbonate is fire-retardant materials, please stay away from the fire ,to avoid  softening deformation.

Frame maintenance:

  1.The frame is aluminum alloy structure, if there is a white problem can wipe with a cloth in time, under high temperature and wet environment.
       All frames are made of alloy aluminum. White spots may appeared under wet-hot environment, just wipe it.

  2.If there is any distortion calibration shall be carried out in a timely manner in order to avoid sunshine board out, If Polycarbonate out of frame, please removed

     screws. Carried out in accordance with the manual installation steps, and partial restoration.Any distortion calibration shall be carried out in a timely to avoid the

     sunshine board fall off. Repair work should  be according to the IM.

   3.If connection piece serious rust, should change in time the new screws and connectors to ensure connection parts are firm

     Please replaced the serious rust screws and connection for stable.

How to do in bad weather:

  1.If there is lightning may not stay in the shed, because aluminum alloy skeleton is conductive and will be caused serious consequences

     Do not stay under shed when lightning.

  2.Wind power reaches 70 km/h should be prepared ready to defense equipment, fixed wall shed. Fixed method with a strong rope or cable connect the cornice

     work four Angle of anchor  block inserted into the soil or tied in a nearby tree stem > 10 cm in diameter. Pay attention to the weather turns good dismantled after

     the rope or cable to avoid injury and pedestrian.

     Please get defensive measures when facing heavy wind (abt 70km/H). Reinforce by steel rope and anchors which insert into ground or Strapping on a big tree

3.Clear in time at the top of the deciduous leaves led to the decrease of the canopy transparency, heat preservation effect is reduced

   To avoid greenhouses reduced transparency, heat preservation effect is reduced, please clean up the leaves at the top.

4.During snow, removal work in time, if not timely to snow removal, Use solid wooden plate supporting internal intermediate point and middle position of

   polycarbonate, prevent snow collapsing the wall shed.

   To prevent collapsing by snow, please remove the snow in time,Or support by a wooden stick support in the center of the sunshine board for reinforcement

Stick length 320cm±3cm