Customer Service 1-888-707-
1880
Dyaco Canada Inc. 2021
Email: customerservice@dyaco.ca
31
RESET SWITCH RESETTING
•
If your treadmill loses power or will not start, check the reset switch located on the front of the
frame.
•
If the white tab of the reset switch is not showing, then the reset switch has not been
tripped.
•
If the white tab of the reset switch is showing, the reset switch has tripped.
To reset the reset switch:
•
Remove the safety key on the console.
•
Press the white tab of the reset switch until it snaps back into place.
•
If the reset switch continues to trip - see treadbelt adjustment and treadbelt lubrication
SPEED SENSOR ADJUSTMENT
If the monitor does not display in the calibration mode, the speed sensor and magnet may be
misaligned.
(ONLY IN CALIBRATION MODE)
Note: Always unplug your treadmill prior to cleaning to avoid electrical hazard or shock.
Follow these steps to check and realign.
•
Remove the motor cover.
•
Check the spacing and alignment between the magnet on the right side of the front roller
and the speed sensor on the frame. The spacing must be 1/8".
•
Loosen screw and slide speed sensor in or out of the clamp.
•
Retighten the screw and replace the motor cover.
Summary of Contents for 16005107200
Page 19: ...Customer Service 1 888 707 1880 Dyaco Canada Inc 2021 Email customerservice dyaco ca 18...
Page 20: ...Customer Service 1 888 707 1880 Dyaco Canada Inc 2021 Email customerservice dyaco ca 19...
Page 21: ...Customer Service 1 888 707 1880 Dyaco Canada Inc 2021 Email customerservice dyaco ca 20...
Page 22: ...Customer Service 1 888 707 1880 Dyaco Canada Inc 2021 Email customerservice dyaco ca 21...