Customer Service 1-888-707-1880
or email customerservice@dyaco.ca Dyaco Canada Inc. © 2014
17
MAINTENANCE PARTS
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback,
the reed switch or sensor should be adjusted.
To adjust the reed switch, the chain cover (33) must
first be removed.
Remove the left pedal (15L) from the crank arm (11).
Remove all the screws (34 and 63) from the
chain covers (33). Hold the chain cover (33)
near the back and pull it apart slightly.
Next, locate the sensor wire (
71
). Turn the pulley
until the magnet is aligned with the
sensor
.
Loosen, but do not remove,
the screw (72).
Slide the
sensor
slightly towards the magnet
.
Make sure that the magnet will not hit
the
sensor
. Retighten the screw (
72
). Turn the
pulley for a moment. Repeat until the console
displays correct feedback.
When the sensor is correctly adjusted, reattach
the chain cover.
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals
slipping
while you are
pedaling, even when the resistance is adjusted to the
highest level, the drive belt may need to be adjusted.
To adjust the drive belt, the right chain
cover (
33R
) must first be removed.
Next, turn the nut (19) on clockwise to tighten
the belt adjuster (17).
When the belt is correctly adjusted, reattach the
chain covers.
72
94
71
15L
15R
11
1
38
17 19
