CUSTOMER SERVICE 1-888-707-1880 Dyaco Canada Inc.©2014
14
4
Plastic Covers
Note:
Use the Phillips Head Screw Driver (
157
) to tighten the hardware
in this step.
1. Install the two Wheel Covers (
79
-Left &
80
-Right) with four Phillips
Head Screws (
115
).
2. Install the Bottom Cover (
85
) with four Phillips Head Screw (
115
). You
need to raise the incline to install the Bottom Cover.
3. Install the Handle Bar Covers (
81
&
82
-Left,
83
&
84
-Right) with the
eight Sheet Metal Screws (
119
).
4. Install the two ‘Z’ shaped Cover Holders (
24
) as shown with four
Phillips Head Screws (
122
). The Cover Holders should be installed so
the tab with the tapped hole is pointing toward the rear.
5. Install the Inclinable Rail Cover (
87
) with two Phillips Head Screws
(
115
). Install the Rear Bar Cover (
88
) with four Phillips Head Screws
(
115
).
Hardware Step 4
#115
. M5 × 15mm
Phillips Head Screw
(14 pcs)
#119
. 3.5 × 12mm
Sheet Metal Screw
(8 pcs)
#122
. M6 × 10mm
Phillips Head Screw
(4 pcs)
