25
ENGLISH
►
Make sure the display is in the “ON” mode.
►
Make sure the keyboard is not locked and no procedu-
re is currently under process.
►
Press and release the
(1) key, then press
and release the
(2) key: the display will show the
duration of the freezing phase and the operating setpoint
during the freezing process.
►
Press and release the MENU key, then press and release the key
or the key
to select
the duration of the freezing phase and the operating setpoint during the freezing process, other
than the set ones.
►
Press and release the key
or the key
key to modify these values then the ESC key to
save them.
Program: MANUAL
Elapsed time: 0 min
►
Press and release the START / STOP key (1): the cycle
will start.
►
During the freezing soft phase the display will show
the remaining time of freezing , the cell temperature, the
name of the program (if any) and the time elapsed since
the starting of the freezing process.
►
Hold the START/STOP key pressed for 3 seconds to stop the cycle.
►
When the freezing soft phase time is over the control panel will automatically switch to the freezing pha-
se.
►
During freezing the display will show the remaining time of the freezing process, the cell temperature, the
name of the program (if any) and the time elapsed since the starting of the freezing process.
►
When the freezing time is over the control panel will automatically switch to the preservation phase and
buzzer will be sounding. To silence buzzer press and release any key.
.
Program: MANUAL
Cycle time: 240 min
End
►
During the preservation phase the display will show the
cell temperature, the name of the program (if any) and
the duration of the freezing process.