36
ENGLISH
The following are the measures taken to protect against other risks:
-
electricity:
The blast chiller has been designed, built and equipped so as to prevent risks from
electricity, in accordance with the specific legislation in force
-
noise:
The blast chiller has been designed and built in such a way that risks resulting from the
emission of airborne noise are reduced to the minimum level
8.1 safety devices adopted
It is absolutely forbidden (Fig. 2) :
- to tamper with or remove the evaporator housing casing that protects the user against the risk of
being cut by the evaporator fins and the movement of the internal fan
- remove the labels applied at the inner edge of the engine compartment, showing the technical
specifications (1) and the instructions for grounding (2)
- remove the label applied on the evaporator guard and near the electrical wiring inside the engine
compartment, which warns the user to turn off the power supply before working on the unit (3)
- to remove the labels applied inside the engine compartment, indicating grounding (4)
- to remove the label applied on the power cord, indicating the type of power supply (5)
The manufacturer declines any responsibility for the safety of the blast chiller if this were to happen.
1
2
3
4
5
4 2 3
1
2
3
Fig.2
8.2 Indications for optimal operation
- do not block the air vents of the engine compartment
- place the foodstuffs on the appropriate shelves or containers. Do not place them directly on the
bottom, or leaning against the walls, doors or fixed guards
- close the doors carefully
- always keep the defrost water drain hole clear of obstructions
- limit, to the extent possible, the frequency and duration of door opening. Each opening causes a
change in the internal temperature
- perform periodically current maintenance (see chapter 3)
