4. To manually turn ON the Module, press and release the
On/Off button. The LED will turn ON, and the load
plugged into the Module will also turn ON.
5. To manually turn OFF the Module, simply press and
release the On/Off button. The LED will turn OFF and
the load plugged into the Module will also turn OFF.
Programming
Z-Wave
TM
Group Support
The unit supports two association groups with 5 nodes
support for Grouping 1 and 5 nodes support for Grouping 2.
This has the effect that when the unit is operating, all
devices associated with the unit will receive the relevant
reports.
When the unit is powered for the first time, the unit will
send a Notification Report to the node of Group 1.
When setting the unit or changing the unit
’s status, the
unit will send a Binary Switch Report to the node of
Group 1.
When performing Reset the unit will send Device Reset
Locally Notification to the node of Group1.
When the button on the unit or the wall switch is pressed,
the unit will send a Basic Set command to the nodes of
Group 2. When the unit is OFF, Basic Set Value = 0x00.
When the unit is ON, Basic Set Value = 0xFF.
Z-Wave Plus
TM
Info
Role Type
Node Type
Installer Icon
User Icon
Slave
Always On
Z-Wave
Plus
TM
node
On/Off Power
Switch
On/Off Power
Switch
Version
Protocol Library
3 (Slave_Enhance_232_Library)
Protocol Version
7.17.2
Manufacturer
Manufacturer ID
Product Type
Product ID
0x0060
0x0034
0x0001
AGI (Association Group Information) Table
Group Profile
Command Class &
Command (List) N bytes
Group
Name(UTF-8)
1
General Binary Switch Report,
Notification Report,
Device Reset Locally
Notification
Indicator Report
Lifeline
2
Control
Basic Set
On/Off control
Basic commands
Command
Description
Basic Get
Inquire about the status of the device
Basic Report Report the status of the device.
Basic Set
Set the status of the device.(Value=0XFF
(ON), 0x00 (OFF))
Notification
Event
Type
Event
Event Parameters
Length
Power applied for
first time
0x08
0x01
0x00
Configuration
The configurable values are as following:
Remember the last status:
Parameter
Number
Size Range Default
