2408RGBT/DVIT RGBHV/DVI Portable SFP Fiber Transmitter
Revision
1.1
Page - 5
OUT
FIBER
12VDC
FAULT
OK
UNBAL
AUDIO
IN
LOOP OUT
VIDEO IN
COM
BAL AUDIO IN
2408DVIT-A2
Figure 2-1: 2408RGBT I/O CONNECTIONS
2.1. OPTICAL
CONNECTIONS
SFP FIBER OUTPUT:
There is one LC/PC female connector when the 7708RGBT/DVIT is
equipped with an Evertz Transmitter SFP module. The optical output is available in
1310nm, 1550nm, and CWDM (ITU-T G.694.2 compliant) wavelengths. This connector is
compatible with multimode fiber when connected directly to a companion 2408RGBR/DVIR
receiver.
2.2. SIGNAL
CONNECTIONS
VIDEO INPUT:
The 2408DVIT accommodates digital DVI input signals only. The 2408RGBT
DVI-I connector accommodates analog and digital display technologies, promoting optimal
compatibility with different display types. Input DVI signals may be connected directly to
this port. A DB-15 RGB connection may also be accommodated using an industry standard
DB-15 to DVI-I adapter such as the Belkin F2E4162, or appropriately terminated cable
assembly such as the Amp 16539332-1.
"
Note: When making digital DVI connections, Evertz recommends using only high
quality DVI cables, no longer than 6 feet (1.8m).
AUDIO INPUTS (A2 Version):
The 2408RGBT/DVIT-A2 module provides a terminal block for input
connections compatible with either balanced or unbalanced analog audio. Balanced
audio signals should be connected to the positive (+) and negative (-) input terminals.
Unbalanced audio signals should be connected to the positive (+) input terminal, and a
jumper connection should be installed between the negative (-) input terminal and the
ground terminal (
).
2.3.
INTERFACING WITH 3G OPTICAL ROUTER
Figure 2-2 illustrates a typical setup using an optical router with a bidirectional 7708RGBT/DVIT
transmitter and a compatible 2408RGBR/DVIR receiver. To ensure proper system operation in
bidirectional configurations, it is important that the Tx OUT and Rx OUT are both switched at the same
time. This should be taken into account when programming router salvo operations. Note that A2KM-
USB transmitter versions can only be routed to A2KM-USB receiver versions and Non-A2KM-USB
transmitter versions can only be routed to Non-A2KM-USB receivers.
Summary of Contents for 2408RGBT/DVIT
Page 2: ......
