2430RX-J2K-IP
JPEG2000 to HDMI Converter User Manual
Revision 0.1
Page - 9
5.
DECODER CONFIGURATION
5.1.
DECODER INPUT CONTROL
Figure 5-1: Decoder Input Control Tab
Input Stream Active
Input Stream State:
This parameter will activate or deactivate this stream. By default, all streams are
inactive. Once this parameter is set to active, traffic can run through it.
Input Port Select:
This parameter allows the user to set the physical interface to receive data from
either data port 1 or data port 2.
Input IP Address:
This parameter allows the user to define the IP address/ Multicast address from
which data will be received.
Input IP Port Number:
This parameter allows the user to select the input UDP/RTP port number,
which can range from 1 to 65535.
Input Program Control
Program Tuning Mode:
This parameter allows the user to select the program Tuning mode of the
decoder. The user can select from two options:
•
AutoPidSelect:
automatically choose the PIDs for each audio stream, based on Auto
Program Select Mode.
•
ManualPidSelect
: Manually select PIDs for each audio stream.
