Frame Manual
400FR Compact High Density Balanced Audio Distribution Frame
Page - 8
Revision
0.2
5.
INSTALLING AND REMOVING THE MODULES
5.1.
OPENING AND CLOSING THE FRONT PANEL
In order to insert or remove modules you will have to open the front panel. Turn the two captive screws
located on the front panel counter clockwise several turns until they release completely from the front
extrusions. Carefully lower the front panel door so that the front edge of the door is lower than the rear of
the door.
5.2.
INSTALLING THE MODULES
Orient the module vertically such that the white card ejector is on the bottom. Align the card with the card
guide corresponding to the slot number where you installed the rear panel plate. Carefully slide the
module into the frame and press it completely into the rear panel connectors. Make sure that the
connectors are fully seated in the rear panel.
5.3.
REMOVING THE MODULES
Press the card ejector down to release the module. Grasp then the card using the card ejector and pull
the module out from the frame. As the card ejector goes past the front extrusion, you will have to pull it
with slightly more force. Carefully place the module in a safe place, free from static discharge.
