Model 5601MSC
Model 5601MSC Master SPG/Master Clock System
MASTER CLOCK
Revision 2.2
Page - 131
4.4.7.4. Selecting the Tones to Generate on the AES Digital Audio Outputs
OUTPUT
There are four menu items that are used to select the frequencies of the
tones that are generated on the AES outputs. Each AES output is controlled
separately and has two controls, one for the left channel (channel 1) and
another for the right channel (channel 2).
Press the
and
buttons or rotate the control knob to move the selection
cursor (
>
) to the desired frequency. Press the
SELECT
button to make the
selection active on the output.
AES Audio
AES1 Left Freq
AES1 Right Freq
AES2 Left Freq
AES2 Right Freq
20 Hz
60 Hz
100 Hz
200 Hz
400 Hz
800 kHz
1.0 kHz
1.6 kHz
2.0 kHz
3.2 kHz
4.0 kHz
5.0 kHz
6.4 kHz
8.0 kHz
10 kHz
12 kHz
4.4.7.5. Setting the Audio Levels for the AES Digital Audio Outputs
OUTPUT
There are four menu items used for setting the volume of the audio that is
generated on the AES outputs. Each AES output is controlled separately
and has two menu items, one for the left channel (channel 1) and another
for the right channel (channel 2).
The audio level can be set from 0 dBFS to –28 dBFS with the lowest setting
being
mute
which is a digital mute (all zeros). The volume is controlled in
steps of 2 dBFS (decibels Full Scale).
AES Audio
AES1 Left level
AES1 Right Levl
AES2 Left level
AES2 Right Levl
0 dBFS
mute
4.4.8. Enabling the Setup Pedestal for all Sync and Analog Test Generator Outputs
OUTPUT
The
Global pedestal
menu item in the
OUTPUT
root menu is used to control
whether a 7.5 IRE setup pedestal is added to the active video lines of all
NTSC-M outputs. This control has no effect on PAL-B outputs. It affects the
sync and analog test generator outputs.
Global pedestal
Pedestal Off
Pedestal On