5782ENC-H264HD-IPASI
Professional Contribution H.264 and MPEG-2 Encoder
Revision 1.0
Page - 35
Total TS Bit Rate:
This parameter allows the user to select the output TS Bitrate in kbps. The
5782ENC-H264HD-IPASI will automatically adjust the bitrate for video based on audio and advanced
PID configuration to maintain the set TS bitrate.
TS Encapsulation Type:
This parameter allows the user to select the output encapsulation type. The
options are UDP or RTP.
Audio Delay:
This parameter allows the user to select the output audio delay time. Range is from 0
to 200ms.
Encoder Enable:
This parameter allows the user to enable or disable streaming out of the 5782ENC-
H264HD-IPASI. This will stop the IP output and the ASI output when disabled.
Encoder Type:
This parameter allows the user to set the encoder type. Options are H264 or
MPEG2.
Pixel Depth:
This parameter allows the user to set the pixel depth. Options include:
MPEG 2
•
4:2:2 8-bit
•
4:2:0 8-bit
H264
•
4:2:2 10-bit
•
4:2:2 8-bit
•
4:2:0 8 bit
Backup Output Stream State:
This parameter enables or disables SFP 2 to be used for back up.
Backup IP Address (SFP2):
This parameter allows the user to select a streaming output IP address
for the Contribution Backup Encoder. Can be a Multicast or Unicast address.
Backup UDP Port Number (SFP2):
This parameter allows the user to select the destination UDP
port number of the backup streaming output.
Encoder Controls – Basic
PMT PID:
This parameter allows the user to select the PMT PID number of the output stream.
Video PID:
This parameter allows the user to select the Video PID number of the output stream.
AC3 Audio Bitrate:
This monitor displays the bitrate on the AC3 audio.
Audio Assignment
Audio 1-8:
The 5782ENC-H264HD-IPASI has 8x audio encoders onboard. These parameters allow
the user to select the Audio PID number, select the audio start channel pair and select the audio
encoding mode for each audio encoder. Audio encoders can be disabled by selecting off from the
Audio start select. For multichannel standards be sure to choose the correct audio start pair. The
Contribution encoder and the IPTV encoder share the same audio encoders.
