7700 MultiFrame Manual
7707VT-8-HS 8 Channel HD/SDI/DVI-ASI Fiber Transmitter
Page -
8
Revision
1.2
4.2.
DOT-MATRIX DISPLAY / CARD STATUS AND CONTROLS
Additional status monitoring and controls are provided via the 4-digit dot-matrix display located at the card-
edge. The card-edge shaft-encoder/pushbutton (see Figure 4-1) is used to navigate through the display
menus. To select an option, press the shaft-encoder/pushbutton. Figure 4-2 provides a quick reference to
the display menu structure.
BACK
(Abort)
Pushbutton
Ö
Fault Status
Menu Level 1
Menu Level 2
CTRL
(Control)
Selections
STAT
(Status)
VER
(Software Version)
Software Version
Indications
Selections
FRST
(Factory Reset)
BACK
(Abort)
DISP
(Display Orientation)
VERT
(Vertical)
HORZ
(Horizontal)
Selections
YES
(Accept)
NO
(Abort)
Menu Level 3
Selections
VID1
(Video Input 1)
×
Shaft
Encoder
Ø
MON
(VID8 Monitor
Output)
Menu Level 4
VID8
(Video In/Out 8)
Standards Per Table
MON
(Set to Monitor Output)
!
∆
VID8 Output Only
Indications
LOS
(Loss of Signal)
IO...ERR
(Input/Output Fault)
LINK
(Optical Link Output)
Selections
VID1
(Video 1)
VID7
(Video 7)
USED
(Used for Transport)
PSWD
(Password Protect)
0-9999
(Enter Password)
!
∆
Factory Default = 7154
Selections
Selections
VID1
(Video 1)
VID8
(Video 8)
NEW
(New Password)
0-9999
(Enter Password)
Selections
ON
(Enable Channel)
OFF
(Block Channel)
Selections
PSWD
(Password Blocked)
OFF
(Monitor Off)
SLOT...ERR
(Slot Error)
Supersedes
XFP...ERR
(XFP Error)
Supersedes
LASR...ERR
(Laser Error)
Supersedes
OK
(Normal
Operation)
Indications
Menu Level 5
FULL
(Link Capacity Full)
USE
(Link Capacity Usage)
0% to 100%
(Usage)
Indications
Selections
Values from XFP
(nm)
Indications
NA
(Not Available)
WL
(Nominal Wavelength)
+S
(Standard-Haul Option)
Indications
NA
(Not Available)
HAUL
(Distance Option)
+M
(Medium-Haul Option)
+L
(Long-Haul Option)
TXP
(Transmit Power)
Selections
Values from XFP
(dBm)
Indications
NA
(Not Available)
Figure 4-2: Card Edge Menu Structure
If a specific menu selection has a configuration value associated with it, then this may be changed using
the shaft encoder. Pressing the pushbutton will apply the displayed value and return you to the previous
menu level.
The most recent user selection will be maintained in non-volatile memory in the event of power
loss to the module.
