7700 MultiFrame Manual
7707VT-8-HS 8 Channel HD/SDI/DVI-ASI Fiber Transmitter
Page -
12
Revision
1.2
4.2.9. Password Protection for Channel Blocking
The
PSWD
menu item allows the user to set the channel blocking for each of the individual video inputs.
This function is password protected. To enter the menu, use the shaft encoder to select
CTRL
in level 1 of
the menu. Use the shaft encoder to display
PSWD
and push the shaft encoder to select it. By turning the
shaft encoder, enter the correct password (Default
7154
).
After the correct password is entered, turn the shaft encoder to select
VID1
through
VID8
and
NEW
.
Pushing on the shaft encoder when each channel is shown, will open the selection of
ON
(Enable Channel)
or
OFF
(Block Channel) for that particular channel.
CTRL
PSWD
Enter Password
VID1 to VID8
ON
OFF
The following indications are available:
ON
Enables the selected video channel.
OFF
Blocks the selected video channel.
The user can set a new password by selecting the NEW option from the menu.
CTRL
PSWD
Enter Password
NEW
0 – 9999
(Enter Password)
Selecting
NEW
rather than a channel will allow the user to define a password
(
0-9999
).
4.2.10. Setting the Orientation of the Text on the Card Edge Display
The display option allows the user to set a horizontal or vertical orientation for the card edge display
messages. To set the display orientation, select the
CTRL
menu item in menu level 1, use the shaft
encoder to display the
DISP
menu selection and use the pushbutton to select it. Use the toggle switch to
change between
HORZ
and
VERT
and press the shaft encoder to make your selection.
CTRL
DISP
HORZ
VERT
The possible selections are as follows:
HORZ
Horizontal display used when the module is housed in the 1
rack unit 7701FR frame or the stand-alone enclosure.
VERT
Vertical display used when the module is housed in the 3-rack
unit 7700FR frame.
