7780MD Series
DVB-S/S2/S2X L-Band and IF Satellite Modulators
Revision 1.0
Page - 7
7. Select option 1 in the main menu to view the IP, Netmask, Gateway, and Broadcast addresses.
Changes to the addresses may be made by selecting the desired option on the
Network Setup
screen shown in Figure
2-4 and pressing
ENTER
.
Figure
2-4 : Network Setup Screen
8. After making the changes, choose
X
and press
ENTER
to exit.
9. Again, choose
X
and press
ENTER
to exit and save or choose
W
to exit without saving.
10. The frame controller can now be used with the new IP address.
2.4.
HTTP BROWSER CONTROL
The user can control the 7780MD using an HTTP browser by following these steps:
1. Connect a network cable (RJ-45) between the management connector labelled
ETHERNET
on
the chassis and the LAN connector of the local PC or switch.
2. Open Firefox or Chrome browser (latest version recommended) and type in the control port IP
address from Section
Note: The PC used for management and administrative purposes must be in the same
subnet to establish proper connection to the chassis. User may need to change the
user’s PC IP settings for DHCP to static during the management IP connection.
3. Log in as:
root
, password:
evertz
Note: The default username and password is “root” and “evertz” respectively. This is
for read/write privileges.
For read only privileges, the customer needs to access with username and password
“customer” and “customer” respectively.
