7882DM2-LB4-CA2-ASI Series
Satellite DVB-S/S2/S2X Demodulator
Revision 1.0
Page - 19
4.3.
OUTPUT
Figure
4-7 : WebEASY
®
- Output
To monitor the TS output and change the TS output settings, follow the steps below:
1. Click on the
Output
tab.
2. Navigate to the
TS Out Status & Control
section under
Output
tab
to monitor the ASI output.
3. Press
Reset Counters
and then
Refresh
to get an accurate reading of the monitoring
parameters.
4. Under the same section, user can monitor the presence status of TS output along with other
parameters such as Bitrate, PID count, Sync Loss Error, Sync Byte Error and CC errors present
in the transport stream.
5. To navigate between different TS, click on tabs 1 to 2.
TS Status:
This parameter retrieves the output TS present state: Loss or Present.
Bitrate:
This parameter retrieves the output TS bitrate in kbps.
PID Count:
This parameter retrieves the number of PIDs in the output transport stream.
Sync Loss Error:
This parameter retrieves the sync loss error count in the output transport stream.
Sync Byte Error:
This parameter retrieves the sync byte error count in the output transport stream.
CC Error:
This parameter retrieves the continuity count error count in the output transport stream.
Reset Counters:
This parameter clears the TS output status.
