IntelliGain
User Manual
Revision 1.6
IntelliGain
- 15
3.3.
SETTING THE OUTPUT LEVEL THRESHOLD (1, 2, 3)
Program 1
The
Output Level Threshold
control is used for real time monitoring and
SNMP trap alarming. By defining the output level, the IntelliGain
system will send an SNMP alarm to VistaLINK
®
if the output loudness
level exceeds the defined output level. For example, by setting this
control to –18
LKFS
, if the calculated output loudness level exceeds –
18
LKFS
(for the specified fault duration) then an alarm will be sent to
VistaLINK
®
for immediate operator notification. There are 3 levels of
alarm thresholds. These can be setup as minor, major and critical
alarming thresholds.
Output Level
Threshold (1,2,3)
-65 LKFS to –1 LKFS
3.4.
SETTING THE FAULT DURATION
Program 1
The
Fault Duration
control defines the amount of time that the
IntelliGain
system detects the output level has been exceeded. For
example, if this control is set to 25 seconds; this means that the output
level has to be exceeded for a minimum of 25 seconds before an
SNMP trap alarm is sent to VistaLINK
®
.
Fault Duration
0.5 to 240 seconds
3.5.
SETTING THE CLEAR DURATION
Program 1
The
Clear Duration
defines the amount of time that the IntelliGain
system must be corrected to before a correction SNMP trap is sent to
VistaLINK
®
. For example, if this control is set to 10 seconds; this
means that the IntelliGain
output level fault must be corrected for a
minimum of 10 seconds before a correction alarm is sent to
VistaLINK
®
. This control is primarily used to smooth out alarming for
audio with a very wide dynamic range.
Clear Duration
0.5 to 240 seconds