EVGA Corporation 2900 Saturn St. Suite B, Brea, CA 92821
Phone: 888 / 881-EVGA - 714 / 528-4500 - Fax: 714 / 528-4501
Page 13
To install a CPU, locate the ZIF socket and open it by first pulling the lever
sideways away from the socket then upward to a 90-degree angle. Insert the
CPU with the correct orientation as shown on the previous page. The notched
corner should point toward the end of the lever. Because the CPU has a corner
pin for two of the four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No force is required to insert the
CPU. Press the lever to Locate position slightly without any extra force.
2-4
Install Memory
This motherboard provides
four
184-pin DDR DUAL INLINE MEMORY
MODULES (DIMM) slots for DDR memory expansion available from minimum
memory size of 64MB to maximum memory size of 4.0GB DDR SDRAM.
Valid Memory Configurations
Generally, installing DDR SDRAM modules to your motherboard is very easy,
you can refer to the following page to see what a 184-Pin DDR266/DDR333/
DDR400 DDR SDRAM module looks like.
Bank
184-Pin DIMM
PCS
Total Memory
Bank 0, 1 (DIMM1)
DDRDDR266/DDR333/DDR400
DDR SDRAM Module
X1 128MB~1.0GB
Bank 2, 3 (DIMM2)
DDRDDR266/DDR333/DDR400
DDR SDRAM Module
X1 128MB~1.0GB
Bank 4, 5 (DIMM3)
DDRDDR266/DDR333/DDR400
DDR SDRAM Module
X1 128MB~1.0GB
Bank 6,7 (DIMM4)
DDRDDR266/DDR333/DDR400
DDR SDRAM Module
X1 128MB~1.0GB
Total System
Memory
(Max. 4.0GB)
4
128MB~4.0GB
For Dual Channel Memory
Dual channel only operates when 2 DIMM Modules are plugged into either
DIMM1 & DIMM3 or DIMM2 & DIMM4, or four DIMM Modules are
plugged into DIMM1~DIMM4.
DIMM1 & DIMM3, or DIMM2 & DIMM4 must be the same type, same size, and
same frequency for dual channel to function.
Note:
Computer will not boot if RAM is in 3 and 4 only.
