E
F
5. Firmly tighten the set screw against the flat face of the motor shaft, using
the short end of the hex wrench (
E
).
6. Tighten the second set screw on the pulley, again using the short end of the
hex wrench.
7. Use the same method to add the second pulley to the second motor (
F
).
§2.3 Add pulleys to motors, continued
13
Summary of Contents for AxiDraw MiniKit 2
