2.6 Mounting the EBB
1. Identify the EBB Driver Board
#18
, and the EBB Support
#19
. You
will also need the four long, black M3×16 Button-head Screws
#20
,
the White Nylon Washers
#21
, the Black Nylon Spacers
#22
, and the
M3 Kep Nuts
#23
. The spacers are short black plastic tubes, and the
nuts are distinguished by having a built-in toothed washer.
2. Slide a white nylon washer over each screw (
A
), and then insert the
screws through the four corner holes of the EBB (
B
).
3. Holding the EBB vertically with the power jack facing sideways as
shown (
C
), slide one of the black nylon spacers over each screw.
Place a finger over each screw head as you slide its spacer on, to
prevent the screw from popping out of the hole.
#18
#21
#22
#23
#20
(Continues on next page)
A
B
C
Tip:
Rest the EBB on top of the Base Rail for easy access.
Tip:
If you have difficulty with this step, it may be helpful to put
a small piece of tape over the screw heads.
17
Summary of Contents for AxiDraw MiniKit 2
