§4.12 Tuning the Y carriage, continued
B
C
2. If you can feel any slack movement in Pair 1 alone, make
a small adjustment to the position of the eccentric
spacer beneath the SemiHex standoff (
B
). Repeat un-
til there is no slack movement in line with these two
wheels. The pair is properly adjusted when there is no
slack movement when tested as in (
A
), but a wheel in
the pair can be rotated with a little effort.
3. If the eccentric is difficult to turn, you may need to
slightly loosen the screw below it. If it comes fully loose,
tighten it versus the SemiHex Standoff.
4. Once Pair 1 is properly adjusted, repeat these steps for
Pair 2.
5. Once both wheel pairs are tuned, tighten the eccentric
in place. Hold the base of the SemiHex standoff steady
with the 10 mm low-profile wrench
#5
while you tight-
en the wheel securely in place with the short side of
the 2.5 mm hex L-wrench from the bottom (
C
). Check
again to make sure that both wheel pairs are properly
adjusted.
52
Summary of Contents for AxiDraw MiniKit 2
