5.3 Stepper wiring 2
1. Attach the Short Motor Wire Harness
#53
to the left-
hand stepper motor, with its loose end guided through
the gap by the motor above the Long Motor Wire Har-
ness (
A
).
2. Guide the wires over through the vertical slot, above
the other Wire Harness (
B
).
3. Connect the four wire ends to the upper four positions
of the EBB terminal block (
C
) and tighten each well.
The wire order is again Gray, Green, Red, Yellow, bot-
tom to top.
A
B
C
Tip:
It may be easier to position the wiring harness
through this gap first, before connecting it to the
motor
58
Summary of Contents for AxiDraw MiniKit 2
