Inspection I:
The LED locations have a
squared-off pad and a rounded pad.
Make sure– for each LED –that the
short lead
is at the
rounded pad
.
Inspection III:
The leads of each LED
should point straight up, not at an angle.
If not, nudge the LED to correct it.
Inspection II:
Check that all of the LEDs are
roughly pointing towards the center and in the
same plane– not wildly pointing up or down.
Finish adding the four short standoffs.
This loosely “clamps” the LEDs in place.
The four long standoffs can now be
removed. (You may prefer to wait until
after the upcoming inspection steps.)
Use the hex wrench to gently tighten
the four short standoffs in place. Only
go to “finger tight” Do not overtighten.
[Bulbdial Assembly Guide]
[24]
STEP 19: Clamp & inspect the ring of LEDs
OK
OK
May need
adjustment
After inspection, remove the four long
standoffs (if you have not already done so).