[Bulbdial Assembly Guide]
STEP 22: Finish soldering the first ring
[27]
Next: We’ll test the assembly thus far, and
point the LEDs in the final configuration.
Part A
: For each of the 30 LEDs,
solder the remaining lead, and then
trim all the leads short on both pins.
+ Side
- Side
The 100 uF capacitor (if present)
is a small, plastic-covered cylinder.
Orientation matters:
The “-” side of
the capacitor is marked with a
broad stripe. Match that to the “-”
side of C5 on the circuit board.
Part B:
Your Bill of Materials
may
list a
part
#27
, which is a 100 uF capacitor.
If so
, install it at location C5.