[Bulbdial Assembly Guide]
[9]
#6
If you have the mono kit:
Install one more 24-ohm
resistor (
#6
) at location R10.
If you have the RGB kit:
There should already be a
68-ohm resistor installed at R10, as shown here.
STEP 6: The rest of the resistors
The last resistor type is part
#6
, a 24 ohm
resistor (color code red-yellow-black-gold).
Install nine of these in locations R1 - R9.
Those resistors are located in the three
highlighted locations.
Don’t forget R8!