Setting the Ghetto Board
Each time you press the Dwell button, the light should blink Green. The led glows Orange
once any setting has been adjusted to its maximum or minimum.
Board Adjustments-Instructions for ROF, ETS and BIP
Hold down the trigger and switch on the gun. Keep holding the trigger until the led
changes from Orange to Red (4 seconds). If the led stays unlit then the EVIL
®
Pimp Kit
™
is locked–see Tournament Lock Section. You’re now in the settings menus and the gun
should now be blinking Red. To cycle through the different options, pull the trigger. The
led flashes a color to indicate the option selected. Red=Ball In Place, Orange=Rate
of Fire, Green=Electronic Trigger Sensitivity. Just hold down or press the up or down
Dwell buttons located under the grip on the left side of the marker to change the setting
of each option. Each time you press the Dwell button, the light should blink Green.
The led glows Orange once any setting has been adjusted to its maximum or minimum.
When you’re done changing all the settings, just turn the gun off and then on again
and you’re ready to go.
Ball in Place Adjustment (BIP)
This delay allows the the paintball to fully seat in the chamber. Raise the BIP delay if you
are using a slower hopper or having problems chopping or breaking paint.
Rate Of Fire Adjustment (ROF)
The ROF adjustment only affects the EVIL
®
Pimp Kit
™
when eye is off. The EVIL
®
Pimp Kit
™
has an uncapped rate of fire with the eye on.
Electronic Trigger Sensitivity (ETS)
This allows the sensitivity of the EVIL
®
Pimp Kit’s trigger switch to be adjusted. The lower
the number, the higher degree sensitivity. Some fields and tournaments are very strict
about bounce and this allows you to customize your gun so it is always legal.
Reset Function
This will reset all adjustments done to the board back to the default stock settings
(below). It can be done only when the Tournament Lock is disabled. To reset the board,
hold the trigger for a full 20 seconds while turning the marker on. The led will strobe
between Green and Orange when it has been reset.
4ms
20ms
10ms
1/2ms
1bps
25bps
12bps
1bps
1ms
127ms
10ms
1ms
0ms
2.0
0.1
Dwell
min
max
default
increment*
ROF†
ETS
Ball in Place
25.5ms
†ROF only affects the marker when the eye is off.
*increment is how much it changes when you press the up or down button.
Stock Settings
The EVIL
®
Pimp Kit
™
ships from the factory already tuned, and with regular cleaning
and lubrication should only require pressure regulator adjustments to set the velocity
and avoid shoot down.
Respirator LPR Adjustment
The LPR should be set at about 100-150 psi. If the EVIL
®
Pimp Kit
™
is not getting correct
velocity even after adjusting the Detonator
™
or it is shooting down, see page 19 for
instructions on how to lubricate and adjust the LPR. If the LPR leaks, turn it down. The LPR
should vent at 170 psi. Degas marker before adjusting LPR.
Velocity Adjustment EVIL
®
Detonator
™
Regulator
Adjust your velocity using the Detonator
™
Vertical Regulator. Please see page 11 for
instructions.
NOTE: As gas pressure is increased, velocity first increases to a maximum and then
decreases.
Dwell Adjustment
Dwell adjustment is how long the valve is held open. Higher Dwell usually leads to
higher velocity. Dwell adjustment can be made in any live mode and it can be adjusted
whether the Tournament Lock is on or off. The Dwell buttons are located directly on the
left hand side of the board and are visible once the grips are removed. The upper button
adjusts the Dwell up and the lower button takes the Dwell down.
Eye Settings
Turning the Eye On
The Anti-Chop Eye
(ACE) turns on automatically when the marker
is turned on. The led light indicates what
the ACE is doing. Orange–No ball in chamber.
Red–Trigger has been pulled and marker is
waiting for a ball to load. Green–Ball is loaded
and ready to shoot.
Override Eye
To override the eye for one
shot, hold in the trigger for 3/4 of a second.
The Pimp Kit
™
will fire once, but the eye will not turn off.
Turning the Eye Off
To turn the eye off, hold the trigger down and turn the marker on.
Once the marker is turned on, release the trigger. The light will blink Green even when
there is no ball in the chamber. You can adjust the ROF with the eye off. See next page.
Tournament Lock
The Pimp Kit
™
comes stock with the Tournament Lock on. Tournament Lock mode is
toggled if both Dwell buttons are held when the power is turned on. The light will turn
solid Green when the Tournament Lock is OFF. The light will turn solid Red when the
Tournament Lock is ON. Once the Tournament Lock has been changed, the Pimp Kit
™
must then be turned off and on again to adjust settings. The Tournament Lock must be
turned off to adjust the BIP, ROF, ETS or use the reset function.
Dwell Up
Dwell Down
Tuning
Tuning
23
22
Summary of Contents for Pimp Kit
Page 1: ...Version 1 0...
