If you are installing a secondary lens or light trespass shields, attach to the luminaire prior to hanging the luminaire.
Please see the separate instructions for installing these accessories in the field. Installing a photocontrol, steps
8 and 9 may be easier to perform on a workbench than on a pole. Likewise, setting the FAO (Field Adjustable
Output switch), step 7, can be done in advance, prior to installation.
1.
Disconnect the power to the luminaire.
2.
Open the access panel using the access panel knob by rotating approx. 2 turns. Panel will hang securely.
3.
Using the ½ inch drive socket, loosen (do not remove) the
two tenon clamp bolts enough to allow the mounting arm
(not included) to slide into the service cavity. Mounting arm
should be placed upon or ‘stopped’ against the leveling steps.
Use caution and avoid striking internal components with
the mounting arm.
Leveling steps are +/- 5° tilt: +5, +2.5, 0, -2.5, -5 degrees.
4.
RoadMax RX1 accepts mounting arms with a maximum outside diameter of 1-5/8 & 2-3/8 inch.
Luminaire is set at the factory to accept 1-1/4 inch mounting arm.
Note: A wildlife guard is provided for use with a 1-1/2 inch diameter mounting arm. If using a
mounting arm larger than 1-1/2” remove the wildlife guard. See instructions for Installing or
Removing the RoadMax Wildlife Guard.
5.
Tighten the bolts to 75 in-lbs, alternating from bolt to bolt. Refrain from tilting the clamp or unevenly
tightening the bolts to avoid cross-threading.
6.
Pull the wires through the mounting arm. Allow for enough length to easily attach to the three-position
terminal block. Loosen the terminal block screws prior to connecting wires. Use 1/4 inch slotted
screwdriver for securing conductive wires in the terminal block, torque to 15 in-lbs.
a.Connect the green wire, or ground, to the terminal block at the GND location
b.Connect the black wire, or hot, to the terminal block at the L1 location
c.Connect the white wire, or neutral, to the terminal block at the L2(N) location
Note: A reference wiring diagram can be found inside the access panel. RoadMax is sold with pigtail
options. Exact steps may vary depending on if pigtails (white and black wires} are sold with the luminaire
vs. a no pigtail option.
3600 Lind Ave SW, Suite 140, Renton, WA 98057 425-336-5800 evluma.com
ROADMAX SERIES LUMINARIES
INSTALLING THE ROADMAX LUMINAIRE
REAR VIEW
wildlife guard
dia. 2-3/8
dia. 1-5/8
-5
-2.5
0
+2.5
+5
