7. If you have ordered a luminaire with an FAO (Field Adjustable Output switch) installed and you intend to
use this to set a lower wattage, do so at this time if you have not done so already. Please refer to the RX1
datasheet for details.
8.
Rotate the photocontrol socket if position requires adjustment. By default, North is oriented to the front of
the luminaire. Use a #2 Philips screwdriver for photocontrol socket or photocontrol only if rotation is
required. Torque to 25 in-lbs.
9.
Insert a twist lock photocontrol (not provided) or network node (not provided) into the photocontrol socket
and install in accordance with the manufacturer’s instruction.
10.
Close the access panel. Tighten the access panel knob. Do not over tighten.
11.
With power on, test the photocontrol.
Note: Photocontrols and photocontrol test response times may vary. Some photocontrols may turn the
light off and on over the first few minutes after power is applied. This does not indicate a defect. A
defective photocontrol will operate with the light on at all times regardless of the time of day. Allow several
minutes for the photocontrol to turn the fixture off. A small number of photocontrols fail off. Test according
to the type of photocontrol in use.
If the luminaire comes with the Evluma integrated photocontrol, “XP” model, allow up to 5 seconds for the
luminaire to respond.
PHOTOCONTROL FAILSAFE
If the RoadMax has been ordered with Photocontrol Failsafe the luminaire will flash once to indicate that power is
connected, and luminaire is in operation. The RoadMax begins collecting data immediately. Short daytime tests of
the photocontrol will not affect the gathering of this data.
WARRANTY
Warranty information may be found at evluma.com.
Components inside the fixture are not serviceable.
Copyright © 2022 Express Imaging Systems, LLC. Evluma, RoadMax, ConnectLED, and Photocontrol Failsafe are trademarks of Express Imaging Systems, LLC. All rights reserved. Content is subject to
change. MET labs logo is a registered trademark of MET labs.
NEED ASSISTANCE?
Please feel free call us at 425-336-5800 M-F, 8pm- 4pm PST, or email customercare@evluma.com.
