Step 10
:
Attach the Pec Dec Support (16) to
the Pec Dec Base (6) using two 1/2"
x 3-1/8" Hex Head Bolts (71), four
1/2" Washers (89) and two 1/2"
Nylon Nuts (93).
Insert the axle of the Right Pec Dec
Arm (10) into the sleeve on the Pec
Dec Support (16) then attach with
one 1/2" Nylon Nut (93) and one
1/2" x 1-1/4" Washer (88). Cap the
1/2" Nylon Nut (93) with one Cap
For Nut (55).
Cap the Right Pec Dec Arm (10)
with one 2" Round End Plug (51).
Slide the Rubber Ringlet (68) onto
the Right Pec Dec Arm (10). Attach
one Elbow Pad (32) to the Right Pec
Dec Arm (10) using two 3/8" x 1"
Hex Head Bolts (81) and two 3/8"
Washers (90).
Repeat the same procedure for
attaching the Left Pec Dec Arm (11)
to the Pec Dec Support (16).
Firmly tighten all fasteners at this
time.
ASSEMBL
Y
assembly instructions
-16-
