Announcement
What contained in this User Manual does not represent the commitments of EVOC
Company. EVOC Company reserves the right to revise this User Manual, without
prior notice, and will not be held liable for any direct, indirect, intended or unintended
losses and/or hidden dangers due to installation or improper operation.
EVOC
is a registered trademark of EVOC Intelligent Technology Co., Ltd. All
trademarks, registered trademarks, and trade names used in this User’s Guide are the
property of their respective owners.
EVOC Intelligent Technology Co., Ltd. ©2008, Copyright Reserved. No part of this
manual may be reproduced in any form or by any means, such as in electronic or
mechanical way, without permission in writing from EVOC.
Safety Instructions
1.
Please carefully read the users’ manual before handling the product;
2.
Before inserting, removing or reconfiguring the boards, please firstly disconnect
the AC power or unplug the AC power cable from the power source to prevent
damage to the product and ensure your personal safety;
3.
Before removing this product, please firstly unplug the AC cable from power
source;
4.
When inserting or removing boards, please firstly unplug the AC power cable
from power sources;
5.
Before connecting or disconnecting any signal cable, make sure all power cables
are unplugged in advance;
6.
To avoid unnecessary damage caused by turning on/off computer frequently, wait
at least 30 seconds before returning on the computer.
7.
All the operations such as upgrade, remove or installation shall be implemented
on the ESD worktable, because some exactitude components are sensitive to
electrostatic discharge (ESD).
8.
If there's no ESD worktable, please take the following steps to prevent damage
from electrostatic discharge (ESD):
a)
Wear a antistatic wrist strap and connect it with the metal part of the
corresponding product;
b)
Always touch the metal chassis or frame before touching any components;
c)
Keep part of your body in contact with the metal chassis to discharge the
static while handling components;
d)
Avoid all unnecessary movement;
e)
Hold the components (especially the boards) by the edges;
f)
Place the components on a grounded, staticfree operating platform. Use a
conductive foam pad if available (not the component wrapper).
g)
Do not let the components slide on the operating platform.
9.
Use crosshead screwdriver to operate. A magnetic screwdriver is recommended
(magnet helps to collect screws). Do not leave any tools or screws inside the
chassis;
10. Assure abundant cooling and ventilation.