Debugging
EVOC-SY532
· 21 ·
Pin
Signal Name
1 GND
2 +12V
3 FAN_IN
CPUFAN1/MXMFAN1
4 FAN_PWM
Note: FAN_IN: fan speed pulse output; FAN_PWM: fan speed PWM control.
2. 3Pin fan connector (pitch: 2.54mm Wafer TJC13)
Pin
Signal Name
1 GND
2 +12V
SYSFAN1
3 FAN_IN
Note: FAN_IN: fan speed pulse output.
4.2.13 Jumper Setting
1. JCC1: Clear/Keep CMOS Setting (pitch: 2.0mm)
CMOS is powered by the button battery on board. Clearing CMOS will restore
original settings (factory default). The steps are listed as follows: (1) Turn off the
computer and unplug the power cable; (2) Instantly short circuit JCC1; (3) Turn on the
computer; (4) Follow the prompt on screen to enter BIOS setup when booting the
computer, load optimized defaults; (5) Save and exit. Please set as follows:
Summary of Contents for SY532
