9
© by NECTA VENDING SOLUTIONS SpA
0303 204-00
Chapter 2
INSTALLATION
The machine installation and the following mainte-
nance operations should be carried out by qualified
personnel only, who are trained in the correct use of
the machine and are aware of the specific risks of such
operations.
The machine is not suitable for outdoor installation, it
must be installed in a dry room where the temperature
remains between 2°C and 32°C.
It cannot be positioned where water jets are used for
cleaning (e.g. in large kitchens, etc.).
The machine should be positioned with a maximum
inclination of 2°.
The relative humidity must not exceed 65%.
UNPACKING THE VENDING MACHINE
After removing the packing, ensure that the machine is
intact.
If the vending machine is found to be damaged, immedi-
ately inform the carrier and do not use the machine.
No packing elements (i.e. plastic bags, polystyrene
foam, nails, etc.) should be left within the reach of
children, as they are potentially dangerous.
Packing materials must be disposed of in authorised
containers and the recyclable ones must be recovered by
qualified companies.
If the vending machine had been laid down during
transport, allow at least one hour before connecting it
to the mains.
MASTER/SLAVE BANK
Since the machine does not have its own user interface,
it must be connected to another vending machine that has
master functions.
The master machine must have a numeric keypad to allow
programming operations and vending for the bank of
machines.
It is also possible to configure as master those vending
machines that have direct selection buttons, using the
numeric keypad supplied with the machine.
The bank can be composed of three vending machines, of
which one is master and two are slave; in this case the
selection numbers of the two slave machines must be set
with three digits.
The typical configurations are therefore as follows:
A - Master with direct buttons (adding the numeric
keypad) + slave without interface; all components
required for this configuration are supplied with the
machine.
Fig. 13
1 - Vending machine without
interface
2 - Vending machine with
direct buttons
3 - Vending machine with
numeric keypad
4 -
Additional numeric keypad
Summary of Contents for Snakky SL
