10
© by NECTA VENDING SOLUTIONS SpA
0303 204-00
Fig. 14
1 -
Pre-cut section
2 -
Can-bus connector
3 -
Connector’s holder plate
4 -
Machine securing hole
5 -
Power supply unit cover
6 -
Actuation board
7 -
C.P.U. Board
8 -
Keypad cable
9 -
Numeric keypad
10 -
Slot for keypad flat cable
Using special kits also the following configurations are
possible:
B - Master with numeric slave without inter-
face
B - Master with direct buttons (adding the numeric
keypad) + 2 slaves without interface
B - Master with numeric slave with direct
b slave without interface
Important notice!
When assembling the bank of machines the ventila-
tion grilles of the cooling units must be taken into
account.
Should the grilles be covered, the spacer supplied with the
machine must be fitted (see Fig. 2).
Specific kits are available for the different models to close
the empty space between cabinet and wall.
Warning!
Do not move the vending machines when already
assembled.
It is not possible to lift them or push them and slide them
along the floor, nor can they be transported, without
separating the various machines.
CONNECTING THE VENDING MACHINES
Ensure that the master vending machine is connected to
the power supply.
- Remove the pre-cut section of the external back panel
and eliminate any burrs on the sheeting.
- Insert the can-bus cable inside the cabinet and secure
connector’s holder plate to the back panel with 2
screws.
- From the front of the vending machine, drill a 10-mm
diameter hole on the left side of the cabinet.
- Remove the cover from the power supply unit and
connect the can-bus cable terminal to connector “J4”
or “J6” on the actuation board. Secure the cable and
replace the parts that were removed.
CONNECTING THE NUMERIC KEYPAD
If the master machine is of the type with direct selection
buttons, the numeric keypad (see Fig. 18) must be in-
stalled as follows:
- by removing the pre-cut section make a hole on the
door for the numeric keypad wiring.
- attach the keypad, taking care not to leave any air
bubbles.
- connect the keypad cable to connector J16 on the
C.P.U. board
Summary of Contents for Snakky SL
