Declaration of conformity
The declaration of conformity is
issued under the manufacturer’s
sole responsibility.
The declaration of conformity with
the European Directives and Standards
provided for by the laws in force is supplied
by the first page of this manual, which is an
integral part of the machine.
-
The legal provisions of the European
Directives in force (with the subsequent
amendments and integrations thereof)
-The harmonised standards in force
-
The technical specifications (designa
-
tions) applied in compliance with the
safety rules of good practice enforced in
the EU and listed on the same page.
integration
of
radio
modules
In compliance with Article 17 of Direc-
tive 2014/53/EU (RED), the manufacturer
checks whether the radio equipment is in
compliance with the essential requirements
of article 3 of the Directive.
The procedure used to check compliance
is at the manufacturer’s discretion.
If a radio module is built in a “non-radio”
equipment, the subject integrating the
module will become the manufacturer of
the end product and it must therefore check
the compliance of the end product with the
essential requirements of the 2014/53/EU
(RED) Directive.
As a matter of fact, the integration of radio
modules in other products can influence
the compliance of the end product with the
essential requirements of the Directive.
definitions
according
to
the
law
The
manufacturer
is a natural person who
or a public body which manufactures radio
equipment and/or electric material or has it
engineered, manufactured or marketed by
putting its own trademark or name on it.
An
importer
or
distributor
who places
radio equipment or electric material on the
market by putting its own name or trade
-
mark becomes the manufacturer.
An
importer
or
distributor
who makes any
change to radio equipment or electric mate
-
rial already placed on the market to such an
extent that the said change may condition
the compliance with the listed directives
is held to be the manufacturer and it must
therefore assume the relative obligations
according to the said directives.
Symbology
The following symbols may be present
inside the machines, according to models
(signs of danger)
Attention: dangerous voltage
Power off before removing the
cover
Attention
Danger of crushing your han
-
ds
Attention
Hot surface
The signs of danger must be readable
and visible; they shall be neither hidden
nor removed. Damaged or unreadable
labels must be replaced.
