01-2019 5505 00
53
TEST
This group of functions is intended to test
the main components of the machine.
t
Est
sElEctioN
Use this function to simulate the normal
dispensing mode of products without in-
serting the amount to check the operation
of the spiral rotation by pressing the selec-
tion buttons.
m
otor
tEst
It is intended to operate all motors in se-
quence and to display the selection number
in question.
autotEst
A function is implemented in the software
to check the correct operation of some de-
vices half-automatically.
Some tests occur automatically whereas
others require the manual operation of the
component under test. Press
to perform
the next test.
The following devices are controlled:
-Temperature: To display the temperature
value measured by the probe.
In case of interruption of the electric con-
nection of the probe, -11.0 will appear
In case of a short-circuit of the probe, 41.0
will appear.
-Buzzer: A series of sounds is produced to
check the operation of the acoustic signal-
ler.
-Compressor: Press
and
to activate
and deactivate the compressor.
-Selections: To activate all selections in a
sequence.
-Coin mechanisms: to make sure that the
communication with the coin mechanism
is properly working and to check which
validator lines are set up as active.
-Photocells: If the device intended to de-
tect the product passage is available, the
light beam readout and interruption are
checked.
-Compartment Lock: If the device intended
to prevent the dispensing compartment
from opening is available, press keys
and
to lock and unlock the compartment
opening.
-Display: all points of the display are turned
on to check the correct operation
-LED lighting: all LED's are powered on to
light up the glassfront.
Never look at any source of light directly
during the test.
-Direct selections: The machine shows the
direct key to be pressed, if the required
key can properly work, the key under test
will be the next one.
-Softvend lift: The machine places the soft-
vend at the tray heights you have set up
-Door opening: The machine requires the
door to be opened and closed.
