01-2019 5505 00
59
COMMUNICATION
This menu is intended to group the commu-
nication functions of the device.
up-kEy
sEtup
maNagEmENt
upkEy
->
vENDiNg
macHiNE
After having inserted the Up key into the
plug on the C.P.U. board, this function is
used to select the setup file from the list on
the display. Press the Enter key to load the
setup file you have selected on the ma-
chine.
vENDiNg
macHiNE
->
upkEy
After having inserted the Up key into the
plug on the C.P.U. board, this function is
used to save on the Up key a setup file with
the same configuration currently available
on the machine.
Please specify the name you wish to assign
to the file (e.g. VENDM000.STP)
DElEtE
Use this function to delete one or more than
one setup file on the up key you have in-
serted.
DElEtE
all
Use this function to delete all the setup files
on the up key you have inserted.
upkEy
statistics
maNagEmENt
vENDiNg
macHiNE
->
upkEy
Confirm this function after having inserted
the Up key into the plug on the C.P.U. board
to save on the up key the statistics file with
all the statistical data currently available on
the vending machine. Please specify the
name you wish to assign to the file (e.g.
VENDM000.STA)
DElEtE
Use this function to delete one or more than
one statistics file on the up key you have
inserted.
DElEtE
all
Use this function to delete all the statistics
files on the UpKey you have inserted.
v.m.
sElEctioN
To univocally identify the machines acting
as "slave" (data are sent to the "master"
machine by means of a modem).
Number 0 identifies the "master" machine.
FAILURES
The electronics monitors the machine and
as soon as a malfunction is found out, a
message appears to display the type of
failure and the machine (or part of it) is set
out of order.
The failures that are found out are stored in
special counters.
The failures managed by the software may
be related to functional groups not available
on the specific model. However, they are
listed in scrolling menus.
rEaDiNg
failurEs
Possible failures are listed here below:
-Compressor: the machine stops if the
compressor remains active for over 24
consecutive hours.
-Coin mechanism: the machine stops if it
should receive an over 2-sec. pulse on a
validator line or if the communication with
the coin mechanism is not longer than 30
(Executive protocol) or 75 (BDV protocol)
seconds.
