-5-
When CLEAN/CRUNCH channel is on, the output power LEVEL indicator shows current
power/volume level of CLEAN/CRUNCH channel (
see OUTPUT POWER section
).
OVERDRIVE channel
Channel includes:
1. GAIN knob for channel gain adjustment
2. MODE indicator showing on/off status and mode of the channel
3. MODE switch for activating the channel and selecting the mode
4. BASS knob for low end tones adjustment
5. MIDDLE know for mid range tones adjustment
6. TREBLE knob for high tones adjustment
The channel has the following modes:
MODE
6
RED
+16dB boost, high compression
5
MAGENTA
+8dB boost, normal compression
4
YELLOW
+10dB boost, high compression
3
GREEN
+3dB boost, normal compression
2
CYAN
+5dB boost, very high compression
1
BLUE
high compression
When OVERDRIVE channel is on, the output power LEVEL indicator shows current power/volume
level of OVERDRIVE channel (
see OUTPUT POWER section
).
FX LOOP section
AMBER 40 features a serial FX LOOP with signal level switch (
see Back panel
).
The -10dBu level should be used for stompbox-type effects, while the +4dBV level is for the rack-
type effects. RED colour of FX LOOP indicator means the FX Loop is active. Enabling/disabling of
the loop in the BLUE and CYAN modes (
see Footswitch working modes
) is done by footswitch
button or front panel FX LOOP switch (upwards). In the preset footswitch modes the status is
changed by front panel FX LOOP switch (upwards) and is stored as a preset parameter. This
allows to change the amp's sound and simultaneously switching on/off the effect plugged into the
FX LOOP.
STORE switch
STORE switch is used to store channel settings, presets and other settings of the amplifier. Short
flashing of indicators confirms saving.
REVERB knob
The REVERB knob is used for reverb-type effect volume control.
Summary of Contents for AMBER 40
Page 14: ... 14 ...