First position the eaFreshwater cabinet.
PLEASE NOTE: Your finished aquarium should be away from doors, and radiators,
out of direct sunlight and near to, but not directly over, power sockets.
POSITIONING THE CABINET
One litre of water weighs one kilogram (1kg) so your finished aquarium with sump will
weigh at least as much in kilograms as its total volume in litres.
The cabinet must be placed on a strong, level concrete floor, and must be perfectly
level and positioned before being filled with water. An uneven floor will cause stress to
the cabinet and aquarium.
ADJUSTING THE CABINET DOORS
NOTE – Only adjust doors at the end of the installation and when the tank is filled
with water.
There are three points of adjustment on
each hinge.
1. Height.
The cabinet doors can be height adjusted
marginally with the screws as shown.
Loosen the screws on both hinges and the
door will drop down. Lift door and tighten
screws and the door will raise, and stay in
position.
2. Front to back.
The door can be brought forward by
loosening the screw as shown. Pull door
out or push in and tighten screw to hold
position.
3. Left to right.
Adjustment of the screw as shown will
enable left and right alignment of the door,
and adjustment of both hinges on the door
this way can square up, and will affect the
gap between each door when closed.
Quick release
eaFreshwater hinges are quick release.
Push the button at the back of the hinge to
release the door, without having to undo the
screws.
INSTALLATION
11
Height
Adjustment
Front to Back
Adjustment
Left to Right
Adjustment
Quick
release
