SAVE THESE INSTRUCTIONS FOR
FUTURE USE.
CAUTION:
IF YOU USE THIS HEATER IN CONJUNCTION WITH A
THERMAL CONTROL A PROGRAM CONTROLLER A TIMER
OR ANY OTHER DE
V
ICE THAT SWITHCHES THE HEATER
ON AUTOMATICALL Y REMEMBER TO OBSER
V
E ALL SAFETY
WARNINGS AT ALL TIMES. THE FIREPLACE HEATER HAS
SAFETY O
V
ERHEAT PROTECTION. IF THE O
V
ERHEAT
PROTECTION TRIPS SWITCH OFF ALL SWITCHES AND WAIT
A PPRO
X
IMATELY 5
-
10 MINUTES. IT SHOULD RESET
AUTOMATICALLY ONCE THE UNIT COOLS DOWN.
WARNING:
PROCEDURES AND TECHNI
Q
UES IF NOT CAREFULLY
FOLLOWED WILL RESULT IN DAMAGE TO THE
EQUIPMENT,AND WILL E
X
POSE THE USER TO THE RISK OF
SERIOUS INJURY,ILLNESS OR DEATH.THIS ELECTRIC
FIREPLACE HEATER IS FOR USE ON 120
V
OLTS.THE CORD
HAS A PLUG AS SHOWN AT A IN ILLUSTRATION BELOW. AN
ADAPTER AS SHOWN AT C IS A
V
ILABLE FOR CONNECTING
THREE
BLADE GROUNDING
TYPE PLUGS TO TWO
SLOT
RECEPTACLES. THE GREEN GROUNDING LUG E
X
TENDING
FROM THE ADAPTER MUST BE CONNECTED TO A
PERMANENT GROUND SUCH AS A PROPERLY GROUNDED
OUTLET BO
X
. THE ADAPTER SHOULD NOT BE USED IF A
THREE
SLOT GROUNDED RECEPTACLE IS A
V
AILABLE.
A 15 AMP CIRCUIT IS RE
Q
UIRED TO OPERATE THIS HEATER.
IF THE BREAKER TRIPS WHEN THE HEATER IS USED,YOU
MAY NEED TO MO
R
E THE HEATER TO ANOTHER
LOCATION OR UNPLUG OTHER APPLIANCES THAT ARE ON
THE SAME CIRCUIT. IF YOU RE
Q
UIRE AN E
X
TENSION
CORD,USE ONE THAT IS RATED AT 175 WATTS.
C!:!)
@
C!:!)
a
(A_ADAPTER
�....__ GROUNDING
l!I
MEANS
AA21O
METAL SCREW
�
COVER GROUNDED
([J)
.- OUTLET BOX __,
I]
PARTS LIST
Fireplace .................................................................. 1
A) Anchor screw ............................................................ 5
B) Wall anchors ............................................................. 5
C) Mounting bracket ...................................................... 1
✓
A
B
TOOLS REQUIRED: LEVEL, ELECTRIC DRILL, DRILL BITS (BMM (S/16 IN)), PHILLIPS
HEAD SCREWDRIVER, HAMMER, SAFETY GOGGLES AND GLOVES
INSTALLATION
Please be aware: that no products should be sealed against
the wall/opening as this can effect the performance of the
heater unit.
700mm
300mm
Minimum Installation Height:
From floor level to bottom edge of product, Minimum 300mm.
This suite is supplied with a wall fixing Bracket.
The suite can be installed at any height as long as it is not
below the recommended 300mm. (Please note the 700mm
measurement is given as a common installation height).
The recommended installation height is a minimum of
300mm from the floor level to the underside of the hearth.
