11
www.evolutionpowertools.com
EN
DE
FR
MOUNTING UNUSUAL or UNCOMMON MITRE SAWS
If your mitre saw is ‘uncommon’ or ‘unusual’ an adaptor plate
may be necessary.
The adaptor plate can be bolted to the two (2) saw mounting
brackets, and when attached to the stand should provide a
suitable mounting platform for most mitre saws.
The mitre saw can then be screwed or bolted to the adaptor plate.
We recommend at least 25 mm thick plywood or a piece of
32mm or 40mm kitchen worktop for this adaptor plate.
Consult the manufacturer of the saw for any special
adjustments, other requirements or fixings etc needed to
permanently mount your saw to a worktop.
• A square or rectangular piece of plywood, or worktop
should be sourced which will fit the ‘footprint’ and
mounting hole configuration of your saw.
• The adaptor plate should be drilled and bolted to the saw
mounting brackets using appropriate bolts, or fixings etc.
• The adaptor plate can then be attached to the mitre saw
stand and the mitre saw positioned upon the adaptor plate.
• For stability during use, care should be taken to ensure that
the mitre saw is positioned on the adaptor plate so that
most of the bulk and weight of the saw is centrally located
over the two (2) mitre saw stand crossbars.
• Use suitable fixings to attach the mitre saw to the adaptor plate.
• Check the stability of the machine and installation over the
full range of operating conditions.
Note:
Usually the machines fence should align as closely as
possible with the centre-line of the mitre saw stand rear crossbar.
Summary of Contents for 005-0001
