9
www.evolutionpowertools.com
EN
DE
FR
CHECKING and ADJUSTING THE SAW MOUNTING
BRACKET CLAMPING PRESSURE
The pressure exerted by the clamping mechanism within a saw
mounting bracket can be adjusted. The clamping pressure of
each bracket should be checked before it is attached
to a mitre saw.
When fitted across the mitre saw stands two main crossbars,
and with the locking handle in the down (locked) position,
a bracket should be firm and exhibit no signs movement.
Excessive force to deploy the locking lever to the down
position should be avoided. Gently pressing the lever
downwards with the palm of a hand should be all the force
needed to operate the locking lever.
To adjust the clamping pressure:
• Turn the clamp upside down to reveal the mechanism.
• Loosen the locking nut.
(Fig. 8)
• Turn the adjustment screw
(Fig. 9)
clockwise to increase
the clamping pressure. Turn the screw counter-clockwise to
decrease the clamping pressure.
• Tighten the locknut when adjustment is successfully
completed.
Fig. 5
Fig. 6
Fig. 7
Fig. 9
Fig. 8
(a)
(b)
Summary of Contents for 005-0001
