Evolution 047-0001 Original Instructions Manual Download

Page: 23 / 108

RESETTING THE LOCATING LUGS

• Gently push the protruding lug into the

Carriage arm.

• Gently ease the locating lug deployment plunger

forward by using a flat bladed screwdriver (not
supplied) as a lever.

(Fig. 9)

The carriage slides two

(2)

arms should be inserted

through the two linear bearings contained within
the bevel neck.
The carriage slide should be inserted from the back
ensuring that the ‘Evolution’ logo is the correct way
up.

(Fig. 10)

• Slide the sliding carriage arms through the bevel

neck for approximately half of their length.

• Screw the carriage slide locking screw into the

threaded hole above the right hand arm of the
carriage slide.

(Fig. 11)

Note:

Ensure that the anti-vibration spring is fitted

underneath the hand knob before fitting the
locking screw into its service position.

• Tighten the locking screw to lock the sliding

carriage into the desired position.

ATTACHING THE CUTTING HEAD

• Align the cutting head with the two

(2)

sliding

carriage arms.

(Fig. 12a)

• Push the cutting head onto the Carriage arms

firmly until the ‘click’ of the Locating Lugs
deploying is heard.

(Fig. 12b)

Note:

The deployed locating lugs must be fully

visible when viewed from the side of the cutting
head.

(Figs. 13a, 13b, 13c)

The Locating Lugs are coloured green to make
identification easy.

THE MACHINE TABLE EXTENSIONS (Fig. 14)

Note:

Two

(2)

machine table extension pieces are

provided with this machine.

TO FIT THE TABLE EXTENSIONS:

• Remove the socket headed screws

(Fig. 15)

from

the table using the hex key provided.

• Position the relevant Extension piece onto the

table and secure it into its service position using
the socket headed screws.

• Repeat for the second Extension piece.

ROUTING THE POWER CABLE

WARNING:

This machine is equipped with a mains

cable and a moulded plug which satisfies the
regulations of the receiving country. This cable and
plug, if damaged, should only be replaced with
genuine Evolution replacement parts and be fitted
by a competent technician.

• Ensure that the cutting head is in the

down position.

• Ensure that the carriage slide is in its most forward

position and locked.

(Fig. 16)

From the motor the mains cable should bypass the
front cable guide and then be routed rearwards

(Fig. 17).

The cable should be inserted into the rear cable
guide/clamp. Ensure the Cable Grip Component
is inside the cable guide when the cable
passes through.
This guide/clamp should then be fastened to the
rear sliding carriage cross piece (right hand side)
using the self tapping cap screw (included).

(Fig. 18)

Note:

The cable should not be tight anywhere

along its length.

(Fig. 19)

Raise and lower the cutting head several times
and also operate the sliding carriage. Check that
the cable does not become entangled with any
other parts of the machine. Check also that the
cable is not stretched during any of the operating
procedures. Secure the cable using the cable clip.

Note:

The cable clip can be used to prevent the

cable becoming loose during storage or transport.

(Fig. 20)

UNLATCHING AND RAISING

THE CUTTING HEAD

(Fig. 21)

WARNING: To avoid serious injury, NEVER

perform the locking or unlocking procedure

unless the saw is OFF and the blade stationary.

To release the cutting head from the locked down
position:
• Gently press down on the Cutting Head Handle.
• Pull out the head latching pin

(Step 1)