2
Operating Instructions
Important
Please read these operating and safety instructions carefully and
completely. For your own safety, before using this equipment
check that the voltage is correct and that all handles and parts are
firmly secured. If you are uncertain about any aspect of using this
equipment contact your distributor.
Please Keep These Instructions
Model EVO230-HDX Specifications
Motor (230v or 115v 50/60 Hz) (Watts):
1750
Maximum Box (1/4” 6mm Wall 90
0
):
3-1/4” 84mm
Maximum Box (1/4” 6mm Wall 45
0
):
2-1/16 53mm
Optimum Cutting Thickness (Mild Steel Plate):
1/2” 12mm
RPM No Load (min-1):
2700
Recommended Maximum Duty Cycle (Minutes):
30
Sound Pressure Level (Under Load) (dB(A)):
108.7
Vibration Level (Under Load) (m/s
2
):
3.9
Weight:
19-3/4lbs 9.0kg
Maximum Dimensions: 14-1/2”x15-3/4”x19-3/4” 370x400x500
Minimum Dimensions: 10”x12-3/4”x19-3/4” 250x325x500
Blade Dimensions
Maximum Diameter:
9” 230mm
Bore Diameter:
1” 25.4mm
Thickness:
1/16” 2mm
Standard Equipment Supplied With Unit: 1 Side Handle, 1 Fence Guide,
1 Safety Goggles, 1 Spanner attached to unit, 1 Carry Case, 2 Batteries,
Ear Plugs, 1 Operating Instructions.
Ear and eye protection MUST be worn while operating this
equipment. Do NOT touch the blade while it is in motion. Always
follow the Personal Protection Equipment (PPE) recommendations
while operating this tool.
This machine is designed for cutting steel using the appropriate TCT
(Tungsten Carbide Tipped) blades and accessories. It should NOT be
modified and / or used for any application other than for which it was
intended, including powering other equipment.
Ensure that the total work area can be viewed from the operating position.
Use barriers to keep people away. Do not operate the tool in explosive
environments – power tools create sparks that may ignite flammable
materials or gases. Do not operate the tool in damp or wet conditions,
as electric shocks may result. Always use both hands to operate the
tool. Always ensure that the material you are working on is securely
clamped.
•
This tool is equipped with an approved cord and plug for its intended
Country of use.
•
Remove plug from power supply before replacement of the blade,
making adjustments or other maintenance work.
•
Use only genuine EVOLUTION brand saw blades.
•
Inspect the machine and blade before
each
use and do not use
deformed, cracked, worn or otherwise damaged blades.
•
Ensure the blade is correctly mounted and is appropriate for the
material to be cut.
•
Do not use blades made of high-speed steel.
•
Do not use blades that do not comply with the characteristics
specified in these instructions.
•
Do not stop the blade by lateral pressure on the disc.
•
Ensure that moveable guards operate freely without jamming.
