7
www.evolutionfury.com
j) Secure work.
Use clamps to hold work
when practical. It’s safer than using your
hand and it frees both hands to operate tool.
k) Do not overreach.
Keep proper footing
and balance at all times.
l) Maintain tools with care.
Keep tools
sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories. Do not
use High Speed Steel (HSS) saw blades, or
blades that are damaged or deformed.
m) Disconnect tools
before servicing and
when changing accessories, such as blades.
n) Reduce the risk of unintentional
starting.
Make sure switch is in off position
before plugging in.
o) Use recommended accessories.
Only use genuine Evolution accessories.
When fitted with the correct blade (Fury
3 Multi-purpose TCT Blade) this saw is
recommended to cut Mild Steel, Aluminium
and Wood.
p) Never stand on tool.
Serious injury could
occur if the tool is tipped or if the cutting tool
is unintentionally contacted.
q) Check damaged parts.
Before further
use of the tool, a guard or other part that
is damaged should be carefully checked to
determine that it will operate properly and
perform its intended function - check for
alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any
other conditions that may affect its operation.
A guard or other part that is damaged should
be properly repaired or replaced.
r). Keep hands out of path of saw blade.
s) Never reach around saw blade.
t) Turn off tool and wait for saw blade
to stop before moving workpiece or
changing settings.
u) Disconnect power before changing
blade, servicing or cleaning.
v) To reduce the risk of injury, return
carriage to the full rear position after
each crosscut operation.
CARRYING YOUR MITRE SAW
Safety Advice
1. Although compact, this saw is heavy. To
reduce the risk of back injury, get competent
help whenever you have to lift the saw.
2. To reduce the risk of back injury, hold the
tool close to your body when lifting. Bending
your knees so you can lift with your legs, not
your back. Lift by using the handhold areas
at each side of the bottom of the base.
3. Never carry the mitre saw by the power
cord or the trigger grip of the handle.
Carrying the tool by the power cord could
cause damage to the insulation or the wire
connections resulting in electric shock or fire.
4. Before moving the saw tighten the slide
lock knob to guard against sudden movement.
WARNING!
Do not use the blade guard as a ‘lifting point’.
The power cord must be removed from the
power supply before attempting to move
the machine.
• Lock down the head using the head
locking pin.
• Move the cutting head to its outermost
position and lock in place by tightening the
slide lock knob.
• Loosen the mitre angle lock knob. Pull up
the mitre angle lever and rotate the table
to either of its maximum settings.
• Lock the table in position using the
locking knob.
• Use the two carry handle cut-outs
machined into either end of the machine
base, to transport the machine.
Place the saw on a secure stationary
work surface and check the saw over
carefully.
Check particularly the operation
of all the machines safety features before
commissioning or operating the machine.
