11
www.evolutionfury.com
ASSEMBLY
1. Assembly of the table stand
Eight cross-pieces are supplied (Fig 1). The black cross-pieces
are for the top of the stand, the green ones are for mid way
fixing. The cross-pieces are paired, with two long and two
short of each colour.
Identify all parts before proceeding with assembly.
1. Fit the flexible rubber feet to the four legs. The two turned
over metal tabs should be guided into the two 25mm slots
in the base of the rubber foot which can then be moulded
around the base of the leg.
2. Select two legs, a long top cross-piece and a long green
cross-piece. Fit the top cross-piece to each leg using one
6mm hex bolt, ensuring that the locating lug on the cross-
piece engages into the rectangular slot in the top of the leg. Fit
the green cross-piece using four 6mm hex bolts. This cross-
piece has sloped ends to accommodate the splay of the legs.
Ensure it is fitted correctly with slope facing upwards. Do not
fully tighten any of the bolts at this stage. This assemblage will
become a side of the stand and should resemble a flat topped
letter ‘A’. See Fig 2.
3. Repeat the above to produce a second side.
4. Using the remaining two top cross-pieces and two green
cross-pieces, join the sides together to form the rectangular
base of the table stand.
Ensure that the mounting holes formed by the top cross-
pieces at each corner of the stand are in alignment. The
machine mounting bolts can be loosely fitted in place as an
aid to alignment. (Front ø6mm x 30mm, rear ø6mm x 55mm)
5. Fit the two cantilever braces to a narrow side. This will
become the rear of the stand. These will provide extra
stability and safety when the saw is in use. See Fig 3.
Fig 1
Parts laid out.
Fig 2
One assembled side.
Fig 3
Close up view brace fitted
to leg.
